PAGE 1 OF 2
COURTYARD CREATIONS INC.
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as a carpet, with its underside facing
upwards. Insert the legs (#2) into the plastic holders
on the underside of the table top (#1) rim. Fasten
them together by using screws (#4). See Figure 1.
FIGURE 1
PARTS LIST
TGS40SA
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
ASSEMBLY INSTRUCTIONS
You will need the following tools:
-Phillips Screwdriver (Not included)
-Hex. Key Wrench (See Part #8)
1
2
2
2
2
4
!
!
!
!
!
!
!
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely
assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
1
8
8
8
4
1
1
4
8
7
6
5
4
3
2
1
HEX. KEY WRENCH 6MM
WASHER d6.5*D13*1.0
BOLT M6*20
CENTER
CONNECTOR WITH RING
LEG
TABLE TOP
17C17A0403001Y4
17KAA0201----Y4
18000337002
17FA05040301-Y4
17C01A0708002Y4
Q’TY
Q’TY
PART
PART
MATERIAL CODE
MATERIAL CODE
PART
NO.
PART
NO.
SCREW ST4.2*12
BOLT CAP M6
TGS40SA-CS05-1
TGS40SA-CS04-1
62TGS40SAY101
STOP
DO NOT RETURN TO THE STORE!
V-4
