PAGE 1 OF 2
COURTYARD CREATIONS INC.
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as a carpet, with its underside facing
upwards. Insert the legs (#2) into the plastic holders
on the underside of the table top (#1) rim. Fasten
them together by using screws (#4). See Figure 1.
1
8
4
1
1
4
8
7
5
6
4
3
2
1
FIGURE 1
HEX. KEY WRENCH 10MM
BOLT M6*15
CENTER
CONNECTOR WITH RING
LEG
TABLE TOP
17C17A0403001YX
17KAC3101----Y3
17C40A0705001YX
Q’TY
PART
MATERIAL CODE
PART
NO.
Q’TY
PART
MATERIAL CODE
PART
NO.
PARTS LIST
TGS38CK
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
ASSEMBLY INSTRUCTIONS
SCREW ST4.2*12
You will need the following tools:
-Phillips Screwdriver (Not included)
-Hex. Key Wrench (See Part #7)
-Hex. Key Wrench (See Part #8)
TGS38CK-CS05-1
TGS38CK-CS04-1
62TGS38CKY101
1
2
2
2
2
4
!
!
!
!
!
!
!
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely
assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
STOP
DON’T RETURN TO STORE!
17KAA0101----Y4
1
HEX. KEY WRENCH 4MM
8
17FC05020601-YX
WASHER d6.5*D10*1.6
V-4
