TCS40PZ
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Fasten the legs (#2) to the underside of the table top
(#1) rim by using bolts (#7). Keep the bolts loose.
See Figure 1.
PARTS LIST
1
1
4
4
4
1
TCS40PZ-CS05-1
TCS40PZ-CS04-1
62TCS40PZY101
13C??2CEA00A002
17C40A0710001YX
17KAA0101----Y4
TABLE TOP
LEG
CENTER
CONNECTOR WITH RING
1
62TCS40PZY102
CENTER CONNECTOR
TILE
BOLT M6*30
BOLT M6*15
HEX. KEY WRENCH 4MM
FIGURE 1
PART
NO.
MATERIAL CODE
PART
Q’TY
1
2
3
4
6
12
17C40A0705001YX
5
8
9
ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
Note:
The tiles can break easily. Therefore, be careful when
you remove them.
Attention:
Make sure that each bolt needed for all steps matches
the corresponding figure to ensure proper assembly.
COURTYARD CREATIONS INC.
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely
assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC No. when contacting the service center.
!
!
!
!
!
!
!
STOP DO NOT RETURN TO THE STORE!
PAGE 1 OF 3
17KAC3101----Y3
1
HEX. KEY WRENCH 10MM
7
2
2
2
2
1
#7 BOLT M6*30
7
V-3
30