Cotech 31-4818, Оригинальное руководство пользователя

Страница: 8 / 48

8
ENG
LI
SH
Fuelling
Fill with 95 or 98 octane unleaded petrol following the Fuelling precautions procedures described above.
Start
Note: Check the oil and fuel levels before starting.
1. Insert the ignition key completely into
the ignition.
The key can not be turned
,
but make sure it is fully inserted.
2. Make sure the choke is set to
cold start mode. Do not use the choke
if the engine is warm.
3. Push the primer bladder 3 times. Cover the vent hole in the centre of the primer bladder when pushing.
In cold weather conditions the engine may need to be primed again. If the engine is warm, press
the primer once.
4. Slowly pull the starter handle until you feel some resistance. Use a quick and powerful motion when pulling
the handle to start. Do not release the handle but keep it in position and then return it to its original position.
5. Once the engine has been started and is warm, slowly move the choke to its starting position.
6. If the engine should stall, restart it with the choke set in the middle position for a short time. Once the engine
is stable, slowly return the choke to its original position.
Operation
1. Plan the area of operation and where the snow is to be removed before starting.
2. Clasp the clutch lever and bring it in towards the handle to begin snow clearance and start the feed screw.
3. Release the lever to stop.
Note: Since the snow blower is driven by the feed screw and has no power to the wheels, it may be
necessary to lift the handle somewhat to allow the feed screw to have better contact with the surface.
Depending on the surface, it may also be necessary to push the machine forward somewhat to achieve
forward progress.
4. Push the handle down somewhat to lift the feed screw from the surface when backing or stopping.
5. To turn off the engine, remove the ignition key.