8
1. Press and glide the battery cover on the back of the remote control, then you can remove the cover.
2. Insert two new alkaline AAA batteries into the battery compartment. Be sure to note the proper polarity.
3. Reattach the battery cover and make sure the locking tab clicks into place.
Notes:
Use alkaline batteries only. Do not use rechargeable batteries.
When replace batteries, always replace both batteries with new batteries, do not mix old and new batteries.
If the air conditioner will not be used for an extended period of time, remove the batteries from the remote
control.
CAUTION
If the liquid from the batteries gets onto your skin or clothes, wash it well with clean water, do not use the
remote control if the batteries have any leakage.
If you eat the liquid from the batteries, brush your teeth and see doctor. The chemicals in batteries could
cause burns or other health hazards.
V.
Multiple Protection Functions
1. Anti-freeze protection function
Compressor, water spraying motor will turn off when compressors running over 10 minutes and tube temperature
(Tp) is continuously
≦
2
℃（
35
℉
）
for 20 seconds under cooling mode, E4 will show on LED display window, the
unit initiates the anti-frost protection and all buttons on control panel (except for power button) are inactive.
Once the tube temperature
≧
8
℃（
46
℉
）
, the protection is relieved to recover into original status, and
compressor apply to 3-minute delay protection.
2. Water-full safety alarm and shut
–off protection function:
Warning sounds when the water volume reached its alarm level in water tank, and unit is automatically stop
working, both water-
full indicator and “FL” on LED window is flashing. You need to drain the condensate for unit
to automatically recover operation. (For more information ab
out how to drain, refer to the “Drainage Instruction”
please).
3. Delay protection function of compressor
This unit offers restart protection to compressor. Except that the compressor may start immediately when the unit
is energized at first time, there is 3-minute start delay after compressor is shut down.
Be sure to note proper
polarity of batteries
