14
2.2 Installation of the filter
Special note: Be sure to install the filters to side panel at first then the filter into back panel.
1.
Aim the end of the filter toward slot then push filter in even force gently into slot.
Notes:
Install the filter with opposite direction of removal.
Install the filter into place gently to avoid any damage.
2.
Clean of handle position and remote control storage area.
1)
Take out the remote control
2)
Clean the handle position and remote control storage area with wet and soft cloth.
Note: Do not drip water into the unit.
X.
End of Season Storage
1. Screw off the drain cover, and then pull out the stopper to drain water completely.
Note: the tilt angle of the unit must be
≦
30
.
2. Keep the unit running in fan mode half day to dry inside of unit completely to prevent from going mouldy.
3. Turn off the unit, pull out plug then wrap the power cord around the wire-winding pillar, insert the plug into the
universal fixing hole at the back panel of the unit, install the water plug and drain cap.
4. Remove the heat exhaust hose assembly, clean and keep it properly.
Notes:
Hold the exhaust hose assembly with both hands when removal.
Push the fasteners aside on exhaust air outlet using your thumbs, then pull out exhaust hose assembly.
5. Pack the air-conditioner properly with soft plastic bag and put it in dry place with appropriate dust-proof
measures and keep the unit away from children.
6. Take out the batteries from the remote control and keep it properly.
Note: Assure the unit is stored in a dry place. All accessories of the unit shall be properly protected together.
