Cosmo LS-1866, Руководство по эксплуатации

Страница: 69 / 94

12 INTERFACE 67
1
1
1
1
INTERFACE
1
1
1
1
.
.
1
1
C
C
o
o
n
n
t
t
r
r
o
o
l
l
I
I
/
/
O
O
P
P
o
o
r
r
t
t
The control I/O port interfaces the tester to an external device such as PLC with the capabilities to control
and receive the test results remotely. This port allows the tester to be integrated into a fully automated line.
a) Connector type:
Leak tester side: DB-37P (XM2C-3712-112 OMRON or equivalent)
Cable side: DB-37S (XM2D-3701 OMRON or equivalent)
b) Connector configuration: NO: Normally open NC: Normally closed
PIN# FUNCTION TYPE PIN# FUNCTION TYPE
1 Reserved 20 Reserved
2 START NO, INPUT 21 CH#3 NO, INPUT
3 STOP NO/NC, INPUT 22 CH#2 NO, INPUT
4 CHARGE HOLD NO, INPUT 23 CH#1 NO, INPUT
5 Master-Preset
*1
NO, INPUT 24 CH#0 NO, INPUT
6 Reserved 25 Reserved
7 Reserved 26 Reserved
8 Reserved 27 Reserved
9 Reserved 28 Reserved
10 DC Power input 29 Reserved
11 Reserved 30 Reserved
12 Reserved 31 WORK NG (HH-NG)
*3
NO, OUTPUT
13 WORK NG(Hi-NG)
*3
NO, OUTPUT 32 MASTER NG(Lo-NG)
*3
NO, OUTPUT
14 Good NO, OUTPUT 33 MASTER NG(LL-NG)
*3
NO, OUTPUT
15 Reserved 34
Time extension
*2 NO, OUTPUT
16 ERROR NO, OUTPUT 35 END (a) NO, OUTPUT
17 STAGE#1 NO, OUTPUT 36 BUSY NO, OUTPUT
18 STAGE#0 NO, OUTPUT 37 Reserved
19 COM for all outputs
*1 Master-Preset value sampling
*2 Timer extension signal is transmitted at the Noise Reduction process execution, or the
Master-Preset value sampling.
*3
NG judgement signal is transmitted during DL3 and END stages. Signal output can be limited to
END stage, or change the output to a hold signal by memory switch setting.
(See Section 10.2.3 → )
HI-NG: It is output when the tested part limit value HI is exceeded.
HH-NG: It is output when the HI is exceeded by +10% (NR limit). (At this point, also HI-NG is
output.)
LO-NG: It is output when the reference part limit value LO is exceeded.
LL-NG: It is output when the LO is exceeded by +10% (NR limit). (At this point, also LO-NG
is output.)
c) Power supplies
Operational power supplies are required to use the control I/O port.
Rated input voltage: 12 to 24 VDC ±10%, 0.2 A max. (external power supplied by the SELV circuit)
Leave the pins marked “Reserved” in the table above opened.
NOTE