Cosatto i-Size, Инструкция по эксплуатации

Страница: 8 / 44

5
Headrest:
5: Adjusting:
Loosen the harness (refer to step 1 ).
Pull back the adjustor (a) and adjust the headrest position (b).
Seat Liner:
6:
When your child’s height is between 40 and 60cm, the child car seat must be
used WITH the seat liner (a).
After your child’s height exceed 60cm, the child car seat can be used WITHOUT the
seat liner.
Handle:
7: Adjusting:
Handle positions:
1:
In vehicle position
2:
Carry position
3:
Stow/Reclined Cradle position
4:
Steady position
Hood:
8: Adjusting:
Removing the hood fabric:
9:
Release the elastic loops from both side of the hood (a).
Release the rear section of the hood fabric from the seat (b).
10:
Release the hood fabric insert from the mounting points (a, b).
Refitting is a reversal of this procedure.
11: Removing hood fabric insert:
Refitting is a reversal of this procedure.
Securing your child in the child car seat:
12:
Open the harness (a), (refer to step 3 ).
Raise the headrest (b), (refer to step 5 ).
13:
Place your child in the child car seat.
Close the harness (a), (refer to step 4 ).
Adjust the headrest (b), (refer to step 5 ).
14:
Tighten the harness (a), (refer to step 2 ).
NOTE:
The harness must be reasonably tight. It should restrain but not make the
child uncomfortable. Check that the straps are not twisted while the child is
seated.
15: Satisfactory shoulder strap position:
Fitting the child car seat to your vehicle:
16:
Adjust the handle to carry position (a) (refer to steps 7 ).
Position the child car seat on the vehicle seat, pass the vehicle waist belt through
the side vehicle belt guides (b) and fasten the vehicle belt buckle (c).
Route the diagonal belt under handle hinge (d) then through rear vehicle seat
belt guide (e).
Tension the vehicle diagonal belt (f).
Adjust the handle to in vehicle position (g) (refer to steps
7
).