Cosatto Bob, Инструкция по эксплуатации

Страница: 9 / 19

1 list of parts
Your pushchair is supplied in one carton and contains:
1 Pushchair (basket attached) 2 Hood with foldout sun visor
3 Reversible seat liner 4 Chest pads
5 Raincover 6 Mosquito net
7 Bottle holder 8 Front Wheel x 2
2 how to open your pushchair
To open the pushchair, fi rst release the catch (
A
) which holds the pushchair in the umbrella
position. Now holding the pushchair by the handles, gently lower the front. To complete
the operation: Press hard on the footrest PRIMARY LOCKING BAR
(
B
) .
WARNING: Ensure that all locking devices are engaged before use.
3 fi tting the front wheels
Fit the front wheel by placing the front leg into the hole provided in the wheel mechanism,
ensuring that it clicks into place. Repeat this process for the remaining front wheel. Although
the wheels are packaged separately they are not designed to be removed when fi tted.
4 using the brake
To apply the brake, press either of the brake levers (
C
) fi rmly with your foot. Test the brake is on by
trying to run the pushchair forward for a short distance. Release the brake by lifting either of the
brake levers
(
D
) with your foot.
5 using the harness
A fi ve point harness is provided to restrain your child. To fasten the harness, push clips (
E
)
into buckle. To unfasten, push clips in and remove from buckle. Sliding adjusters (
F
) are fi tted
on the waist straps and should be carefully adjusted so the harness fi ts your child comfortably.
Adjusting to the smallest size, you will need to thread the adjusters through the ‘D’ ring.
‘D’ rings are fi tted at the end of each waist strap should you wish to attach a separate harness
complying to BS EN 13210.
To reduce the length of the shoulder straps (
G
) tighten as required using the adjusters on the
webbing. The crotch strap (
H
) can also be adjusted as required using the adjuster on the webbing.
WARNING: Always use the crotch strap in combination with the waist belt
6 fi tting seat liner and chest pads
Unfasten the fi ve point harness. Choose the preferred side of the reversible seat liner, thread the
two shoulder straps
(
J
) and crotch strap (
K
) through the seat liner holes. Insert the shoulder straps
through the chest pads (
L
) .
7 fi tting the hood
To fi t the hood, clip the brackets (
M
) over the handle tubes and push down to secure as shown.
Reverse the above procedure to remove the hood. To fold the hood back, lift the two side levers
(
N
) and push the hood.
operation