HomeVision® Pro
© Corroventa Avfuktning AB
2021.02
39 (44)
Alarms and service reminders
In HomeVision® Pro there are a number of alarms and reminders implemented to notify the user
of malfunctions, errors or service requirement.
For all these presentations except the warning for failed log function, the
<Next>
button leads to a
confirmation to actions taken pictured to the right below. When
<OK>
is pressed a log entry is
created in the system so that the time is saved and can be used as support for service technicians for
any later troubleshooting. A table with explanations of the different messages follows the images
below. Note that where it is applicable, the top row of alarms starts with the machine designation it
applies to, in the examples below A1, for the user to know which it applies to if the installation has
several machines.
Screenshot
Explanation
H
o
m
e
Vi
si
o
n
Means that the dehumidifier's heat protection with
automatic reset has been triggered. The dehumidifier
starts automatically again when the temperature has
dropped, but to prevent this happening again the
dehumidifier must be rectified according to this manual. A
likely fault, as the text indicates, is that the filter is blocked.
Confirm with
<OK>
when the fault has been rectified. The
alarm disappears and a log entry is created in the system.
If the problem persists after carrying out the actions
suggested by the manual, contact your retailer.
As the test states, a fault has occurred that must be rectified
by a trained professional. Contact your retailer as soon as
possible as the system cannot now dehumidify the crawl
space if required.
The relative humidity is or has exceeded the alarm level as
set in the system. A suitable first action is to verify that the
set alarm level is relevant, that the current relative humidity
is a problem. Then refer to the dehumidifier's manual for
troubleshooting instructions.
Confirm with
<OK>
when the error has been rectified. The
alarm disappears and a log entry is created in the system.
The control unit is not working and cannot regulate the
dehumidifier correctly. The dehumidifier, like its
integrated fan, now runs continuously to prevent
damaging the building. As continuous operation means
increased energy consumption, contact your retailer as
soon as possible.
This alarm means that the control panel has not heard the
control unit's radio traffic for 60 minutes. If contact is re-
established, the alarm disappears.
First, check that the dehumidifier is powered to ensure that
this is not the cause of the problem. If the problem
persists, restart the dehumidifier and reconnect, pair, the
control panel with the control unit again. If these actions
do not rectify the problem, contact your retailer.
