HomeVision® Pro
© Corroventa Avfuktning AB
2021.02
16 (44)
3.
Remove the batteries from the control panel and connect the battery eliminator. Battery
mode is only intended to operate the control panel for short periods, such as during
installation and service.
4.
Install the control panel by moving it over the wall mounting and pressing downward.
HomeVision® Pro
HomeVision® has an easy-to-use interface with a display and three software-controlled buttons.
Software control means that the respective functions of the buttons vary with the actual menu, in
order to make operation as easy as possible.
The menus that appear are pictured below, with the exception of the alarm indications and
reminders that are described in separate chapters. The setting options are accessed from the status
view via the setup button in the middle. The button to the left, View, presents actual data for all
connected control units whilst the arrow button presents operational-, temperature- and humidity
statistics. The first bar from the right in the statistics views is the current month.
When using HomeVision®, remember the following:
•
If no button is pressed, the presentation in the display usually returns automatically to the
status view after 30 seconds, the only exception to this is when one of the diagnostic menu
tests has been activated.
•
If no button is pressed, the background lighting goes out automatically after 15 seconds.
When the lighting has gone out, the first button press has no function other than to turn
the lighting on.
•
The control unit that is connected to the humidifier is not dependent on the control panel,
for its own function. If the contact between them is broken, the Control unit continues to
control the dehumidifier according to applicable settings.
