HomeVision® Pro
© Corroventa Avfuktning AB
2021.02
15 (44)
NOTE!
The correct date and time must be set
immediately after connection of the first unit,
in order for statistics and logs to be correct.
In status view, normal view, press <
Setup
> to
get to the Administration view where
Date/Time can be found on the first row.
Press <
Select
> and check that the Date/Time
row is marked.
Press
<OK>
to select it.
The first digit, the year, is now marked. Use the
outer buttons,
<
▲
>
and
<
▼
>
to obtain the desired
value and press
<Next>
to edit the next digit. The
date is as follows: Year
–
Month
–
Day.
When the last digit on the row is edited, the
minutes,
<Save>
appears on the centre button
instead of
<Next>
. When the correct digit has
been set, press
<Save>
to finish setting.
Installation of control panel
After the Control unit has been installed and radio contact has been established between it
and the control panel, proceed as follows:
1.
Select a location for the control panel where there is an electrical socket within reach of the
battery eliminator's cable. Before installing, ensure that the signal quality indicator shows at
least two of the maximum five bars. It can take a few minutes before the signal strength is
established. The control panel should be positioned where any operational alarms can be
detected as quickly as possible (the screen lighting flashes in the event of an alarm).
Remember that if the household has small children, the unit should be positioned out of their
reach.
2.
Detach the wall mounting from the control panel by pulling it downwards. Install screws 1 and
2 and hand tighten. Adjust the mounting's angle and tighten the screws. Finally install screw
3. If necessary, drill, using a 5mm drill bit, and use the enclosed wall plug.
2. Adjust the angle and tighten
1
3
1. Install screws 1&2
2
