14 - SHIPPING, HANDLING AND UNPACKING
COROB™ D800 HD
Unpacking and placement
4.3
1 x 10 mm
2 x 17 mm
To remove the fixing brackets
DANGER
The following procedure must be carried out by at least 2 people.
Store the packing material for future use, or dispose of it according to current regulations. In any case, we
recommend that you keep it for the entire duration of the machine warranty.
Make sure the packing has not suffered any damage or tampering during shipping; if so, contact the
authorized technical service or your dealer.
Cut the straps wrapped around the packing.
1.
Remove the covering from the pallet.
2.
Remove machine wrapping.
3.
1
2
3
MAX
MIN
MAX
MIN
MAX
MIN
DANGER
Should the machine appear damaged during shipping, do not attempt to start it and contact the authorized
technical service or dealer.
Loosen all screws
4.
A
holding the brackets to the machine.
Lower the feet (
5.
chapter 4.3.1) so that the machine is slightly raised from the wooden beams on which it
rests.
Remove the wooden beams
6.
B
.
Completely unscrew and remove all screws and nuts fastening each bracket
7.
C
to the pallet.
8.
chapter 4.3.1) until when the machine can move easily on its wheels.
Lower both platforms.
9.
Grasp the machine on the sides (this must be done by at least two people) then slide it slowly along the
10.
platforms on its wheels, then lower it to the ground.
Lower the feet (
11.
chapter 4.3.1) to support and level the machine properly, and make sure that the wheels
are not resting.
