Page of 14
10
9. Find the left side panel of the cabinet (Item 6). Align the pre-drilled holes in the lip of the left side
panel (Item 6) with the pre-drilled holes in the base of the cabinet (Item 13). The holes in the front of
the cabinet base are where the casters will attach. First secure the left side panel to the base using 4
of the supplied screws. Then repeat for the right-side panel (Item 22) of the cabinet.
10. Take a supplied 10 mm bolt and push it through the pre-drilled holes in the lip of the left side panel
(Item 6) and through the pre-drilled holes in the base of the cabinet (Item 13) and then through the
pre-drilled holes in the flange of the caster (Item 12). Secure with a 10 mm nut. Repeat for all 4
mounting holes for this caster (Item 12). Then repeat for the right-side caster (Item 12).
11. Place the middle shelf (Item 5) on top of the side panels (Items 6 & 22). Secure with supplied screws.
12. Using the supplied Philips head bolt, slide on a flat washer and insert it into the pre-drilled holes in
the right side of the plastic door hinge (Item 7). Then insert this assembly into the pre-drilled holes in
the front of the cabinet (Item 8). Add a flat washer, lock washer, and nut onto the back to secure.
Repeat for the other right-side hole in that hinge (Item 7). Then repeat for the other hinge.
13. Using the Phillips head bolt, add a flat washer and slide it through the pre-drilled holes in the left side
of the hinge (Item 7) and through the pre-drilled holes on the front door (Item 8). Add a flat washer,
lock washer, and nut onto the back to secure. Repeat for the other left side hole in that hinge (Item
7). Then repeat for the other hinge.
14. Find the left side vertical panel (Item 3). With the lips out and the wide end to the bottom, align the
bottom two pre-drilled holes in the vertical panel (Item 3) with the threaded holes in the cabinet base
(Item 13). They are located right above the left side caster. Secure with a 10 mm bolt in both
mounting holes. Do not completely tighten these bolts at this time.
15. Going up the left side vertical panel (Item 3), align the next two pre-drilled holes with the pre-drilled
holes in the lip of the middle shelf (Item 5). Secure these mounting holes with a 10 mm bolt and a 10
mm nut. Then tighten the bolts in the previous step.
16. Repeat the last two steps to mount the right-side vertical panel (Item 24).
17. Install the vertical cylinder securement panel (Item 25) on the back of the cabinet box (Items 6 & 22).
This panel will slide between the cabinet box (Items 6 & 22) and the lip of the bottom panel (Item 13).
Align the pre-drilled holes in the left side of the vertical cylinder securement panel (Item 25) and the
pre-drilled holes in the lip of the bottom panel (Item 13) with the threaded holes in the cabinet box
(Items 6 & 22). You may need to use a small screwdriver to help align all three holes. Slide in a 10
mm bolt and leave it slightly loose at this point. Repeat for the mounting holes on the right side of the
vertical cylinder securement panel (Item 25). Then tighten all four bolts.
