CORNING 601-05-011-100, Инструкция по эксплуатации

Страница: 7 / 133

© 2016 Corning Incorporated. All Rights Reserved.
4
Figure 1. Loading the rotor
3.5.
Starting and Stopping a Run
Please refer Chapter 5 Operation to set up your preferred settings of time, speed and temperature.
To start a run, press down the ( START/STOP) knob.
When the pre-set time expires, the centrifuge will stop automatically. To stop the centrifuge prior to
the expiration of set time, press the ( START/STOP) knob again.
When the time is set as “ continuous ”( - - ), the centrifuge will run continuously. To stop the
continuous run, press the ( START/STOP) knob.
By pressing and holding the button, the centrifuge will continue a short-run of set speed. The
short-run will stop if the button is released.
Note:
1. For safety reasons, the (START/STOP) knob will be inactivated when the lid is open. A
symbol “ ” will be flashing until the lid is closed.
3.6.
Emergency Lid Release
When the lid can’t be opened by pressing the button, users can open the lid manually. First, turn
off the power of the centrifuge. Second, use a flat-head screw driver or other tool to remove the
Emergency Lid Release Plug ( Please refer Figure 2 ) on the right-hand side of the machine. Third,
pull the wire (attached to the plug) while gently pushing downward on the lid. The lid will now
release.
Securing
screw