CORNING 601-05-011-100, Инструкция по эксплуатации

Страница: 10 / 133

AxySpin R™ Refrigerated Microcentrifuge
© 2016 Corning Incorporated. All Rights Reserved.
7
5. Operation
Users can pre-set the time, temperature and speed (RPM/RCF) before a run.
Attention: Never attempt to operate the centrifuge with rotors or adapters that show signs of
corrosion or mechanical damage. Never centrifuge strongly corrosive materials that may
damage the rotors, accessories or bowl of the unit.
5.1.
Setting the Time (TIME)
Operating time can be selected from 0.5 min to 99 min or “continuous” . Press button to change
the time setting. The 2 digits of TIME on the display will flash. Turn the ( START/STOP ) knob to
increase or decrease the value. Press button again to confirm the selection or press
( START/STOP ) knob to store and run the selection. The flashing of time value will stop and the
time value will be stored automatically if no button is pressed after 6 seconds of the adjustment.
Operating time can be set as “ continuous” by turning the ( START/STOP ) knob clockwise or
counter-clockwise to make the 2 digits of TIME to display “
- -
“. When the time is set as “Continuous”,
the centrifuge will continue to run without a stop. Press ( START/STOP) knob to end the
continuous operation.
5.2.
Setting the Speed (RPM)
The speed (RPM) can be selected from 500 to 13,500 rpm. Press button to change the speed
setting. The 5 digits of speed (RPM) on the display will flash. Turn the ( START/STOP) knob to
increase or decrease the value. Press button again to confirm the selection or press
( START/STOP) knob to store and run the selection. The flashing of RPM value will stop and the
RPM value will be stored automatically if no button is pressed after 6 seconds of the adjustment.
5.3.
Setting the Centrifugal Force (RCF)
The speed can be selected from 20 to 17,200 x g, too. Press button to change the RCF setting.
The 5 digits of RCF on the display will flash. Turn the ( START/STOP) knob to increase or
decrease the value. Press button again to confirm the selection or press ( START/STOP)
knob to store and run the selection. The flashing of RCF value will stop and the RCF value will be
stored automatically if no button is pressed after 6 seconds of the adjustment.
5.4.
Setting the Temperature (TEMP)
The temperature can be selected from -10 to 40°C. Press button to change the temperature
setting. The 2 digits of temperature on the display will flash. Turn the ( START/STOP) knob to
increase or decrease the value. Press button again to confirm the selection or press
( START/STOP) knob to store and run the selection. The flashing of TEMP value will stop and the
value will be stored automatically if no button is pressed after 6 seconds of the adjustment.