Cornelius VIPER 2 FLAVOR, Руководство по обслуживанию

Страница: 53 / 85

Viper Service Manual
Publication Number: 621260373SER - 48 - © 2008-2012, IMI Cornelius Inc.
Programmed Defrost Scheduling
The control system in the Viper system includes a function to automatically defrost
product in the barrel at programmed intervals based on the viscosity of the product.
Programmed defrosts are scheduled frequently to ensure that product quality within
the barrel is maintained. Failure to defrost regularly during periods of low throughput
allow increased ice crystal size, with a possible decrease in product quality. Regular
throughput of dispensed product replenishs the barrel frequently with liquid and
reduces the requirements for programmed defrosts. The unit automatically senses
the lack of throughput and maintains the product quality by defrosting the barrels
more frequently when throughput is slow.
Sleep Mode Recom-
mendations
Cornelius recommends programming a sleep period for the machine during any
amount of time over 3 hours that the unit is not used. This increases the life of the
machine and reduces energy consumption.
A wakeup time must be programmed after the sleep period to return the unit to nor-
mal operation. Cornelius recommends programming the wakeup time for approxi-
mately 20 minutes before the product is needed. This is the time recommended if the
ambient temperature is at 75°F. The times will vary depending on the ambient tem-
perature (a higher ambient temperature requires more time for the product to cool).
Viscosity Setting
The control system includes a function to select the desired product viscosity. This
function is referred to as “Viscosity Setting”. There are selectable viscosity ranges
from 1-9. The higher the number selected, the more viscous the frozen product in
the barrel becomes. This increased viscosity is achieved by freezing the product in
the barrel to a lower temperature thereby increasing ice crystal size/growth. As the
ice crystal size increases, however, there is potential for product quality to diminish.
Cornelius recommends that the viscosity settings be set at the lowest possible set-
ting to achieve the desired drink quality. In most typical installations using a sugar-
based syrup, acceptable drink quality can be achieved by programmed viscosity set-
tings in the range of 3-5 for Viper.
Diet FCB syrups freeze much more readily than sugar based syrups, so the viscosity
setting should be selected at the minimum value available (which is 1 or 2 for the
Viper).