1
92239
3/11/96
Rev A
IMI CORNELIUS INC.
One Cornelius Place
Anoka. MN 55303-6234
Telephone (800) 238--3600
Facsimile (612) 422--3246
INSTALLATION INSTRUCTIONS
“K” STYLE LID KIT, P/N 08036
These “K”style kits apply to the following ice makers:
Ice Maker
Size
Hoshizaki KM250/450/500/630/650
22
I
Hoshizaki KM800/1200
30
I
Table 1. Loose-Shipped Parts
Item
No.
Part No.
Name
Qty.
1
15260
Cover Assembly, “K”Style
1
2
15303
Bracket
2
3
50904
RTV, Clear, 732, 3 oz. Tube
1
4
15262
Lid, Removable
1
5
70217
#8 Sheet Metal Screw
6
6
90221
Label,
Disconnect Before Cleaning
1
7
70188
Thumb Screw #8-32
¢
1/2
I
1
8
92239
Installation Instruction
1
9
22127
Bracket, LS Mounting
1
1. Set Ice maker lid on the top of the dispenser and position it flush with the back and sides of the dispenser.
2. Using the slotted holes in the lid as a template, drill four (4) .140
I
diameter holes at the bottom of the slots
(see detail A). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four (4) #8
sheet metal screws, two on each side.
3. Seal the ice maker to the top of the dispenser as follows:
A. Run beads of RTV around the opening in the lid and inside the perimeter of the ice maker outline so
that the ice maker will set on the RTV.
B. Set the ice maker onto the lid and position it as required.
C. Wipe away any excess RTV.
4. Remove the two rear screws (only) installed in step 2. Use those screws to install the mounting brackets
(item 2 and/or item 9). Drill 9/64
I
diameter holes into the ice maker cabinet using the bracket as a tem-
plate. Use extreme caution not to drill into any ice maker components (condenser, tubing, etc.). Secure the
brackets using the screws provided.
5. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the
bin thermostat if so equipped or required.
