Safety
Cornelius Deutschland GmbH
Document no. TD0003100
Version 18/03/2019, Index 0
Installation and service manual Tower
Nueva
3
1
Safety
1.1
Intended use
By using the unit as intended you will not only protect yourself, but also prevent damage occurring to the unit and its components!
You can find further information about the intended use of the unit in the tower operator manual, document no. TD0003000.
1.2
Improper use
Improper use of the unit and unauthorised modifications to the unit and its components may cause personal injury and equipment
damage for which Cornelius Deutschland GmbH shall assume no liability. Improper use of the unit is prohibited.
You can find further information about the improper use of the unit – and the meaning of improper use – in the tower operator
manual, document no. TD0003000.
1.3
Staff
There is a clear definition as to what group of people is permitted to carry out what type of work on the unit. You can find further
information about who is authorised to carry out what type of work on the unit in the tower operator manual, document no.
TD0003000.
1.4
Presentation of warnings
The documents supplied with the unit provide warnings regarding any dangers or hazards that might exist. You can find more in-
formation about the design and presentation of warnings in the tower operator manual, document no. TD0003000.
1.5
Safety information
1.5.1
Safety information to prevent personal injury and equipment damage
Any work on the unit and its components which goes beyond operation and beyond the servicing and maintenance tasks that the
operator is authorised for, may only be performed by
experts
(for a definition of experts, see the tower operator manual, document
no. TD0003000). Furthermore, it is crucial that when performing work on the unit all safety information is observed; this information
is set out in the following sections. Some of the tasks may have additional safety information which highlights the specific dangers
or hazards associated with such work.
1.5.2
Safety information for using electrical assemblies
DANGER!
To prevent risks to health and safety, please always observe the following five safety rules:
These five safety rules are to be applied before carrying out work on the electrical system and in the order stated
below. Once work is completed, the safety rules are to be undone again in reverse order.
•
1. Disconnect from power.
•
2. Secure against reconnection.
•
3. Check that the system is disconnected from power.
•
4. Ground and short-circuit the system.
•
5. Cover or separate adjacent live parts.
WARNING!
Risk of burns when touching hot parts of the unit!
Touching parts of the unit after it has been in continuous use over an extended period of time will result in a risk
of burns.
•
Take appropriate safeguard measures, such as by wearing heat-resistant protective gloves.
NOTICE!
•
Make sure that the cable markers are not removed from the cables and/or mark or label the cables such
that they can be correctly assigned during installation.
ATTENTION!
Cables must be fixed in place using cable ties.
When fixing cables in place using cable ties, observe the following points:
•
Once work on the unit is completed, return the area to the same state that you found it in.
•
Using cable ties, combines cables in a meaningful way.
•
When installing cables, be mindful of any bending radiuses that the manufacturer may have specified.
•
To fix cables in place using cable ties, use the mounting bases provided.