TigoMaster 2TH
– EtherNet/IP
User Manual
Copyright © 2021 CoreTigo Ltd.
Page
30
of
75
Note:
When EtherNet/IP communication is initiated, RSLogix transmits parameters to the
TigoMaster 2TH device. Former port configuration parameters set by the TigoEngine
software tool or OPC UA client are overwritten by RSLogix.
To permanently modify port configuration parameters with the TigoEngine software tool or OPC UA client,
parameters should be set using the EtherNet/IP
scanner’s configuration software.
To summarize, there are 3 levels of configuration, namely:
•
IO-Link Configuration
– Used for EtherNet/IP connection types
•
IO-Link Wireless Configuration
– Used for TigoMaster 2TH parameters
•
Port Configuration
– Used for IO-Link Wireless, the TigoBridge device, and SIO mode
Note:
Other IO-Link devices may also be configured.
5.1. EtherNet/IP Scanner
The EtherNet/IP scanner can be used to configure the TigoMaster 2TH IO-Link Wireless. While this manual
describes how to configure TigoMaster 2TH with Studio5000, other available PLC IDEs may work as well.
Prerequisites:
•
Obtain an updated EDS file which may be provided separately or downloaded from the CoreTigo
Ltd. website. The file should be named as follows:
NFD_3090_VX.X_IOLM\W.EDS
•
Components must be connected, and power plugged (as described in previous sections)
•
The TigoMaster 2TH IO-Link Wireless Master must be connected to your PLC
Instructions:
Follow the steps below to configure the TigoMaster 2TH IO-Link Wireless Master using the EtherNet/IP
scanner with Studio5000.
1. To import and install the EDS file, click the
TOOLS
tab in Studio5000.
2. Then, select the
EDS Hardware Installation Tool
option.
Figure 4
– EDS File Installation (a)
