User and Maintenance Manual
Hydraulic brake ID 800
Model ID 800 (disc th. 8 mm)
Model ID 800 (disc th. 12.7 mm)
Date: 2014/07/01
Revision: 1.0
www.coremo.it
Page
6
of
13
5.
Technical data
5.1.
Product performance
The brake is to be used exclusively for service stops.
Use of the product for any purpose other than those indicated may represent a risk to
any aspect of safety.
The ID 800 brake applies a tangential force of 20200 N when powered at a pressure of 100 bar and
attributing a coefficient of friction of 0.4
Warning
:
The value of the friction coefficient is purely theoretical as it depends on environmental
conditions and on how the product is used.
Dynamic torque
The dynamic torque provided by the brake will be a function of the diameter of the disc used and can be
determined using the following equation:
Dynamic torque [Nm] = Tangential force [N] x ( radius of the disc [m] - 0.034 )
An error in calculation will result in a braking torque different to the desired value and a
risk to aspects of safety.
The technical department of COREMO OCMEA can provide information, suggestions and
assistance for correct application and use of the product.
5.2.
Brake lining wear
The thickness of each single new lining is 17.5 mm. A maximum overall lining wear of 10
mm is allowed. Failure to remain within the above limit may represent a risk to aspects
of safety.
5.3.
Special note
During braking kinetic energy is converted into heat caused by friction between the surfaces of
the brake linings and the brake disc. It is therefore fundamentally important to consider the
amount of heat that can be dissipated.
