User and Maintenance Manual
Failsafe hydraulic brake ID 2000N
Model ID 2000N-116
Date: 2014/06/27
Revision: 1.1
www.coremo.it
Page
3
of
25
1.
Introduction
The purpose of this manual is to provide the user with all the information necessary to use the
product properly, independently and as safely as possible.
This manual constitutes an integral part of the safety features and must be read in its entirety
before installation and use of the product. It must therefore be kept in a safe place should future
reference be necessary before proceeding with any kind of work.
The user is strongly advised to read it carefully and to follow the rules and procedures contained
in it as these provide important information concerning safe use and maintenance.
If any doubt should arise concerning the correct interpretation of the instructions, contact our
technical department for the necessary clarification.
It is prohibited for anyone to disclose or modify the content of this manual or to use it for
personal purposes.
2.
Manufacturer
COREMO OCMEA S.P.A.
Via Galilei, 12 - 20090 Assago (MI) - Italy
Tel.: +39 024880697 Fax: +39 024881940
e-mail: [email protected]
3.
General information
Correct use of the product
: In compliance with Italian Legislative Decree
17/2010 and DIRECTIVE
2006/42/EC
the operating limits for perfect and safe use of the product are stated in this manual.
Design parameters
: COREMO OCMEA brakes have been designed in compliance with the norm UNI EN
ISO 12100:2010 and to satisfy the performance requirements and conditions stated in the catalogue and
in Chapter 5 of this manual.
Model selection
: Selection of the correct model for a given application is of basic importance. In the
case of failsafe brakes the service factor must not be less than 2. The technical department of COREMO
