User and Maintenance Manual
Failsafe hydraulic brake ID 2000N
Model ID 2000N-116
Date: 2014/06/27
Revision: 1.1
www.coremo.it
Page
17
of
25
4.
Remove any oil or grease from the surface of the disc using a non-pollutant detergent
product.
5.
If the brake linings are contaminated only on the surface it is a good idea to clean them
using fine emery cloth. If they are contaminated in depth or worn to the limit replace them
with new linings.
6.
Put the brake linings back following the reverse sequence as described in points 3 and 2.
7.
Power up the brake and remove the safety hook (C62257).
(If the brake has been removed
from the machine proceed as described from point 19 to point 21 of section 9.3)
9.3.
Changing the sealing rings
1.
Power up the brake and insert the safety hook (C62257) in its seat of the thruster which
protrudes from the cover (Photo 20).
Photo 20
2.
Cut off the control pressure and disconnect the power line.
3.
Remove the brake from the machine.
4.
Reconnect the power line and power up the brake.
5.
Remove the safety hook (C62257) (Photo 21).
Foto 21
