User and Maintenance Manual
“E” Failsafe caliper brake
Model E4N-ID
Date: 2013/07/01
Revision: 1
www.coremo.it
Page
7
of
14
7.
Installation
THE BRAKE MUST BE INSTALLED WITH THE MACHINE OFF.
Personnel assigned to this work must wear suitable PPE such as gloves, safety footwear and
take any other appropriate precautions to ensure adequate protection and avoid the risk of
injury.
1.
Mount the brake on a rigid flat surface of the machine or on a support capable of withstanding
a tangential force of 46200 N.
2.
The brake can be mounted in any position as it is provided with a balancing system for the
levers and alignment of the brake shoes.
3.
Anchor the brake to the supporting base using 3 class 8.8 M16 screws and a tightening torque
of 200 Nm.
4.
Adjust the screws C61562 located between the levers using a n. 6 spanner (Figure 1), until the
weight of the thruster is balanced; when balanced lock the screw by tightening the nuts
C61608.
Figure 1
5.
Adjust the play between the brake linings and the disc using the play adjuster D71022
(D71076 if with ON/OFF), and a n. 30 Allen key, rotating in the appropriate direction (Figure
2); when a play of 1 mm (with disc of thickness 25.4 mm) or 1.5 mm (with disc of thickness 40
mm) has been obtained between the disc and each brake lining, lock the adjuster in position
screwing the ring nuts (C61711).
