36
PowerBox-Systems − World Leaders in RC Power Supply Systems
3.13.1 Curve Editor
The curve editor enables you to set up special mixing curves.
• Points
Select the number of points – up to a maximum of 33
points.
• Select Point
Use the arrow buttons to select the point you wish to adjust.
The selected point turns green.
• Value
Move the point up or down by altering the percentage value.
• Smooth
The Smooth option can be used to even out the curve, thereby causing the servo to move smoothly over its travel.
• Raw
Raw eliminates curve smoothing.
• Reset Curve
Reset curve sets the curve back to linear travel.
3.14 Preflight Checklist
In the PreFlight Check menu, you can define which transmitter controls are to be checked for correct position when you switch
on, or when you change models. The radio link is not activated until all the defined positions are correct.
Typical examples would be the throttle stick or the retract switch.
–
In the PreFlight Check menu start by switching PreFlight Check on.
–
Activate the button after select.
–
Locate the transmitter control which you wish to have checked in the pre-flight check, and move it. The controls you select are
marked red.
–
If you wish to de-select a control, wait a moment then move the control again.
–
De-activate Select again once you have selected all the transmitter controls.
–
Now move the selected transmitter controls to the position which they are required to adopt when you switch the system on, or
change models.
–
Press the Learn button.
