ALP-20
Surface Mount Slim LED Profile
INSTALLATION GUIDE
ALP20INSTALLGUIDE
|
P1
15024 Staff Ct., Gardena CA, 90248
[email protected] | www.corelightingusa.com
T: 888.737.9192 | F: 888.789.4643
1
WARNING: RISK OF ELECTRICAL SHOCK
* turn off main power prior to installation
* make sure hands are dry
* never touch exposed wires
2
3
PLACE INSULATION ON BOTH ENDS OF THE LED
STRIP. PEEL OFF ADHESIVE BACKING AND ATTACH
ONTO PROFILE. MAKE SURE LED STRIP IS
COMPLETELY ADHERED TO PROFILE.
MOUNT DIFFUSER (LENS) ONTO PROFILE. LENS
WILL SNAP SHUT WHEN IT IS FULLY SET INTO
PLACE.
MOUNT END CAPS. FOR LEAD WIRE GOING
THROUGH THE END OF THE PROFILE, RUN LEAD
WIRE THROUGH END CAP WITH HOLE. USE AN END
CAP WITHOUT A HOLE FOR LEAD WIRES GOING
THROUG BOTTOM OF PROFILE.
End cap
End cap with hole
