13
9.11
NO CAP CHECK
The duplicator has a built in capacity check function which will check the
capacity of the Master drive and the Target drive(s) during Full or Brief copy
processes and determine whether the drives’ capacities are the same.
Tap
the ‘ENT’ button to change this option’s setting.
[ ]
– No Capacity Check is disabled (default). When a Full or Brief copy
process is executed the system will check the capacity between the Master
and Target hard drive(s) to determine whether the capacity is the same. If the
capacity is different the copy process will be cancelled.
[
٭
]
– No Capacity Check is enabled. When a Full or Brief copy process is
executed the system will not check the capacity between the Master and
Target hard drive(s) and start the copy
9.12
HPA CEHCK
The Host Protected Area (HPA), sometimes referred to as the Hidden Protected
Area, is a partition on the hard drive that is not normally visible to an operating
system.
Tap
the ‘ENT’ button to change this option’s setting.
[ ]
– HPA Check is disabled (default). The system will not check for HPA
partitions.
[
٭
]
– HPA Check is enabled. When HPA CHECK is enabled the duplicator
will support Host Protection Areas. When you duplicate a Master Flash that
contains HPA, the system will detect the HPA partition, unlock it, copy the area
and then re-lock the area once duplication is complete.
Note: When you view Device Info (see section ) if the drive info displays
an ‘H’ in the upper right corner then the device contains a hidden Host
Protected Area.
9.13
DCO CHECK
The Device Configuration Overlay (DCO), sometimes referred to as the Hidden
TARGET TOO SMALL !
ESC→NO, ENT→YES
