Section 363-703-103
Revision 01
Page 5
Figure 3. FLC-703 Block Diagram.
7.
FRONT PANEL
7.01
The front panel of the FLC-703 Channel Unit
contains the following indicators (see Figure 1):
•
ACTIVE 1-8 LED Indicators
Green—the channel is off-hook.
Flashing Green—(slow flash) the channel is ringing
(the LED will track the ringing) or the line has been
switched to the test pair.
Off—the channel is on-hook or not connected.
•
FAULT LED Indicator
Red—a fault has been detected by the unit.
Off—no faults are detected by the unit.
C. INSTALLATION AND TEST
8. UNPACKING
8.01
Upon receipt of the equipment, proceed as follows:
1. Unpack each container and visually inspect it for
signs of damage. If the equipment has been
damaged in transit, immediately report the extent
of damage to the transportation company and to
PairGain. Order replacement equipment if
necessary.
2. Check the contents versus the packing list to
ensure complete and accurate shipment. If the
shipment is short or irregular, contact PairGain as
described in Section 5. If you must store the
equipment for a prolonged period, store the
equipment in its original container.
9. TURN-UP AND TESTING
9.01
Table 2 provides step-by-step turn-up and test
procedures for the FLC-703 Channel Unit.
10. TROUBLESHOOTING
10.01
Table 3 provides troubleshooting procedures based
on indications displayed by the front panel
indicators of FLC-703 Channel Unit.
