6
Connect the device to the electric mains, press the «POWER» button,
use buttons on the control panel to select the desired operation mode
and time. You can find accurate description of the meanings of buttons in
section «Control of the device».
To switch the device off, press the «POWER» button. Disconnect the device
from the electric mains. The device must be installed not less than 10 cm
from walls and heating radiators. Full access of air to the device increases
its efficiency and performance.
Do not install the device on a soft carpet or carpet flooring.
Fill the tray with cold tap water up to the water level mark.
Fill the device only with cold water (not more than 30°C). Hot water may
damage drum discs and other parts of the device. It is recommended to fill
in treated (filtered) water. In this case cleaning of drum discs and the water
tray can be carried out less frequently than using tap water.
Regular cleaning of the tray and discs block.
Dirt and all kinds of microorganisms accumulate in the tray during operation.
Thus, the tray as well as the discs block need to be cleaned regularly.
To clean them, use a soap solution and a soft cloth or a sponge. After
cleaning, wash the tray and discs with running water. It is recommended to
carry out such cleaning once a week.
Periodic cleaning of the tray and dampening discs.
In case of a severe contamination of the tray with lime deposits, remove
the discs block, pour it with a citric acid solution at the rate of 1 tablespoon
8. CLEANING AND MAINTENANCE OF THE UNIT
1. When transporting, any possible impacts and movements of the
package inside a vehicle must be avoided.
2. Handling symbols on the unit’s package must be strictly observed when
transporting and storing it.
9. TRANSPORTATION AND STORAGE
Temperature
requirements*
Humidity
requirements*
Transportation and
storage
-30°С to +50°С
15% to 85%
(no
condensate)
IMPORTANT!
Dampening discs are capable of absorbing water
impurities (calcium, lime, iron, etc.) during operation.
Hence, discs need to be cleaned from mineral
deposits once or twice a month, depending on water
quality. See disc cleaning instructions in section
«Recommendation on maintenance of the device».
NOTE:
All elements of the device are made of fragile material. Be
careful, try not to hit them with foreign objects and not to
drop them. Fill the water tray only with clean water without
adding any aromatic or other substances! Otherwise, it
may result in water leakage due to microcracking and
cracking on the tank, as well as loss of its properties and
damage to discs. When adding fresh water, always drain
the remaining one that was used before.
NOTE:
In order to improve the performance of the humidifying
device, you must use warm water, but not above 30°C.
Salt deposits on the discs also helps improve the
humidifying capacity, because salt create additional
micro-structure of the disc surface, contributing to
greater wettability.
The higher the temperature of the air, the faster
humidification.
per 2 liters of water and hold it for 2-3 hours. To clean the discs block,
use a tank that will allow to fully submerge the discs block in the above-
mentioned citric acid solution prepared beforehand. Depending on the
density of deposits and frequency of cleaning, possibly, it will take more
time to soften the deposits.
www.cooperandhunter.com
