P84762 B
Sheet 1 of 3
273 Branchport Ave.
Long
Branch,
N.J.
07740
Thank you for using our products.
(800) 631-2148
(800)
397-5777 INSTALLATION
INSTRUCTIONS
www.cooperwheelockinc.com
WEATHERPROOF
KIT
(W
P-KIT)
WEATHERPROOF FLUSH PLATE AS (WFPA)
WEATHERPROOF FLUSH PLATE (WFP)
Use this product according to this instruction manual. Please keep this instruction manual for future reference.
GENERAL:
Wheelock’s WP-KIT, WFP and WFPA are weatherproof mounting accessories for Wheelock outdoor products.
The WP-KIT allows a customer to surface mount a weatherproof (WP) backbox (IOB, WPBB & WPSBB) to a recessed electrical
box (concealed conduit). The WFP and WFPA kits allow a customer to flush mount WP products (ASWP, MT, MTWP, ET70WP,
RSSWP, AH-12WP, & AH-24WP) without an external WP backbox.
Table 1: Model Code
Mounting Model/Kit
Used
With
Mounting
Figure
Surface Mount to
Recessed Box
WP-KIT
IOB, WPBB & WPSBB
A, B
WFPA
ASWP
C, D, E
Flush Mount to
Recessed Box
WFP
AH-12WP, AH-24WP, MT-12/24, MTWP, RSSWP,
ET70WP & ET-1010
F
GENERAL APPLICATION NOTES:
1.
Please refer to the INSTALLATION INSTRUCTIONS provided for each notification appliance before proceeding with
your installation. These instructions cover the use of
WP-KIT, WFPA & WFP ONLY.
2.
Use mounting screws supplied with this product and mount to backbox as shown in the figures A-F.
WP-KIT APPLICATION NOTES (Figures A-B):
1.
Open rear knockouts in backbox for wire entrance and mounting screws.
2.
Insert plugs into the mounting tab slots.
3.
Remove the backing from the gasket and affix to the back of the WP backbox. Ensure that gasket is flat and centered.
4.
Use mounting screws supplied with this product and mount WP backbox to the recessed backbox in the wall until gasket
compression is even and about half of the original thickness.
5.
For rough or uneven wall surfaces apply outdoor graded silicon caulking around gasket (not supplied).
WFPA & WFP APPLICATION NOTES (Figures C-F):
1.
Use mounting screws supplied to install the adapter plate to the recessed backbox until plate is near to wall surface.
2.
For rough or uneven wall surfaces apply outdoor graded silicon caulking around gasket (not supplied).
3.
Continue to tighten screws until adapter plate contacts the wall evenly.
4.
Use mounting screws supplied to mount appliance to adapter plate. Tighten until gasket compression is even and about half
of the original thickness.
Copyright 2006 Cooper Wheelock, Inc. All rights reserved.
