HALO L630 2C 2N POWER TRAC INSTALLATION INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
When installing or using this track system, basic safety precautions
should always be followed, including the following:
1.
Read all of these instructions before installing the track system.
2.
Save these instructions and refer to them when additions to or
changes in the track configuration are made.
3.
Do not install this track in damp or wet locations.
4.
Do not install any part of a track system less than 5 feet above the
floor.
5.
Do not install any fixture assembly closer than 6 inches from any cur-
tain or similar combustible material.
6.
Disconnect electrical power before adding to or changing the config-
uration of the track.
7.
Do not attempt to energize anything other than track lighting fixtures
on the track. To reduce the risk of fire and electric shock, do not
attempt to connect power tools, extension cords, appliances and the
like to the track.
8.
CAUTION:
This track system is not intended for use with power sup-
ply cord or convenience receptacle adapter.
9
CAUTION:
To reduce the risk of fire and electric shock, use only fix-
ture assemblies marked for use with Halo track and track fittings
marked for use with L630 Series track.
10. The track system is to be supplied by one or two 480V/277V 60Hz
single phase 3-wire system with a grounded neutral.
11. The mounting clips, screws or stems are to be mounted in pre-drilled
holes as follows:
4’ Track - two places - one at each end of track
8’ Track - Three places - one in the center and each end of the track
12’ Track - four places - one at each end of track and 4 feet from
each end
If track requires field cutting, refer to field cutting instructions
12.
CAUTION:
The maximum capacity of L630 Track is 40A per circuit.
When installing, do not exceed the capacity of your circuits. Check
fuses and circuits carefully before installing.
SAVE THESE INSTRUCTIONS
Cooper Lighting • 1121 Highway 74 South • Peachtree City GA 30269 • 770-468-4800
703113
OUTLET
BOX
COVER
LIVE END
CONNECTOR
OUTLET
BOX
COVER
SCREW
MOUNTING
SCREWS
INSTALLATION OF TRACK TO AN OUTLET BOX
Step 1.
Punch out proper knockout holes in ceiling plate for mounting to out-
let box and to live end fitting (note that special smooth plastic finish
piece on metal ceiling plate requires caution in deterring location of
proper knockout before making holes). Remove flat head screw)s)
from back of live end fitting and use to fasten plate to fitting.
Step 2.
Remove cover from live end fitting. Place track with ceiling plate
attached over outlet box and mark on ceiling or wall the position of
the track mounting holes.
Step 3.
Drill mounting holes large enough for toggles and install track with fur-
nished toggle bolts. If track is to be mounted on a solid surface, use
#8 screws (not supplied) instead of toggle bolts.
Step 4.
Fasten ceiling plate to outlet box with two screws. Pull wires from box
through open hole in live end as shown.
Step 5.
Cut and strip wires from box and fasten to screw terminals in live end
fitting (see detail). Push excess wire back into outlet box.
Step 6.
Replace cover on live end and tighten screw.
GREEN
GROUND
SCREW
LINE
NEUTRAL
LINE
NEUTRAL
TIGHTEN SCREW
AFTER INSERTING
IN TRACK
TRACK
Figure 1
