Cooper & Hunter SPWRK-V02, Руководство по эксплуатации и установке, Страница: 3 / 6

3
(5)Remove the cover of indoor unit electrical control box and connect the cable to the terminals A and B of
the terminal board (white).
Printed Circuit Board
Terminal Board
(White)
Mark Band "A"
Mark Band "B"
Cable for Wireless Receiver Kit
Example
Electrical Box
for Indoor Unit
After connecting the cable, bind up the remaining cable length portion by band (Factory-Supplied)
and put them in the electrical control box.
NOTES:
Protective box recommend size
3-59/64
in.(
99.5
)
by
3-41/64
in.
(
92.5
)
by
1 - 3 / 8in.(
35
)
mm, fixed hole center is
3 5/64 in.(
78
)
mm.
Receiver panel with transparent plastic protective film, the official
may required removed according to user.
Remove the cover by using slotted screwdriver.
When the back cover installation, to tidy up wiring, attention to
the back cover marked \"switch\"
that justify the board of SW1 switch position.
If not according to the requirements of sequenced
operations,may cause install or remove substrate difficulties.