8
w w w . c o o l a z o n e . c o m
Operating Procedure & Storage
To store the fan
1. Drain and clean the sump tank. Be sure that the pads and sump tank are
completely dry.
2. Roll up and secure the power cord.
3. Store the fan in a dry area.
To drain the sump tank
1. Power down the unit.
2. Bend the drain pipe downward to let water out.
3. After the water has stopped flowing, place the drain pipe back into the
holding clamps.
Draining the Sump Tank
Control System & the Fuse Box
Temperature Display
When the power is turned on, the temperature of the air being emitted by the fan will
be displayed here.
Water Low
When the water level in the tank is too low to circulate in the system, the warning will
be shown here. The water pump will automatically shut down if the water level gets
too low.
The unit has two fuses for safety: one for the fan motor and one for the water pump. In
the event the fan or water pump stops working, the fuses should be checked to ensure
they are intact.
In order to access the fuse box, remove the control panel cover. Begin by peeling
the cover off at each of the four corners to expose the screws. Unscrew and remove
the control panel. The fuses will be in plain view. Replace any damaged fuses and
replace the control panel by reversing the steps above. NOTE: UNPLUGGING THE UNIT
WHILE POWERED ON COULD BLOW A FUSE.
OPERATING PROCEDURES (CONTINUED):
Storage
DISCONNECT
POWER
BEfORE
WORKING
WITh ThE
fUSE BOX!
