Convotherm 4 Table-Top, Руководство по эксплуатации

Страница: 126 / 144

5.3.8 Emptying and Cleaning the Grease Collection Canister (ConvoGrill
Only)
For your safety when using the unit
Before starting work, read and understand the rules, risks, and hazards specified in 'Safely Using the
Unit' on page 113 and follow all the corresponding instructions without exception.
Handling pumped-out grease / used grease
■
Used oil and used grease must be disposed of in compliance with the relevant country-specific
laws and regulations, as well as in compliance with all applicable rules and regulations set forth by
the relevant local disposal companies and authorities.
■
Do not pour used grease or used oil down the drain and into the sewer system.
■
Do not use pumped-out grease / used grease to prepare meals.
■
Collect used grease in appropriate containers and take it to the appropriate facility.
■
The company operating the combi steamer must brief all staff accordingly.
Required tools
■
Large bottle brush
■
Common household dishwashing liquid
■
Container suitable for pumped-out grease (capacity >> 10 liters)
Grease collection canister characteristics
Do not use any grease collection canisters other than the one included, as the included canister's ma‐
terial is designed to meet the requirements involved in holding hot grease.
Emptying and Cleaning the Grease Collection Canister
1.
Remove the screw closure (1) with the connected tube
from the grease collection canister (2).
2.
Place the screw closure (1) with the connected tube –
with the opening facing upward – in the forked holder (3).
This will prevent grease from flowing out and falling onto
the floor, creating a slip hazard.
3.
When handling the grease collection canister (2), make
sure that no grease falls onto the floor, creating a slip
hazard. This is especially important when moving the
grease collection canister (2) while it is full and open.
Pour the pumped-out grease from the grease collection
canister (2) into the container for pumped-out grease. To
do so, tip the grease collection canister (2) gradually in
order to prevent the grease from sloshing.
4.
Clean the inside of the grease collection canister (2) with
cleaning agent, plenty of hot water, and the bottle brush.
5.
Rinse the grease collection canister (2) with water and let
the water drip out fully.
6.
Screw the screw closure (1) with the connected grease
management tube back onto the grease collection canis‐
ter (2).
7.
Place the grease collection canister (2) in an upright posi‐
tion on a flat, level surface next to the unit. The canister's
(2) supporting surface must not be more than 15 cm
above the contact point between the unit and its base.
The operator's working area must be kept clear.
5 How to Clean the Combi Steamer
Operating Manual 126