Convotherm 4 Table-Top, Руководство по эксплуатации

Страница: 115 / 144

5.3.2 Replacing the Rinse Aid Canister
For your safety when using the unit
Before starting work, read and understand the rules, risks, and hazards specified in 'Safely Using the
Unit' on page 113 and follow all the corresponding instructions without exception.
Required tools
■
One empty canister (10 l) for ConvoCare rinse aid
■
Enough (around 10 l) soft water (for specifications, please refer to the 'Water Quality' sub-section of
the 'Technical Data' section in the installation manual)
■
ConvoCare K concentrate (0.33 l)
Preparing ConvoCare rinse aid in the canister
To prevent undesired foaming, follow the steps below when preparing rinse aid with ConvoCare K
concentrate and soft water:
1.
Open the empty canister (1).
2.
Fill the canister with soft water (2) all the way to just un‐
der the 10-liter marking (4).
3.
Then carefully pour 0.33 l of ConvoCare K concentrate
(3) into the canister (1).
4.
Check the liquid level inside the canister:
■
If the level is below the 10-liter marking (4), carefully
add the required amount of soft water (2).
■
If the level is above the 10-liter marking (4), the rinse
aid's concentration will be lower than specified. You can
still use the rinse aid if this is the case!
5.
Close the canister and mix the liquids thoroughly by shak‐
ing it.
Replacing the Rinse Aid Canister
1.
Remove the cap from the canister in which you prepared
ConvoCare rinse aid.
2.
■
Find the canister that is connected to the rinse aid con‐
nection (F) with a (green) tube and that is located on
the bottom left side of the unit.
■
Unscrew the (green) supply tube (2), together with the
wand, from the canister you just identified.
■
Remove the empty rinse aid canister.
5 How to Clean the Combi Steamer
Operating Manual 115