CONVECTAIR CALYPSO 7826, Инструкция по установке и эксплуатации

Страница: 23 / 27

23
NATURE VERIFICATION ACTION
The heater
does
not emit heat
Make sure the digital screen is on
Press
MANUEL
MANUEL
MANUEL
Auto
.
Press
MANUEL
MANUEL
MANUEL
Auto
repeatedly until you reach the
Comfort mode.
If the screen is still not on Make sure that the circuit breakers are on.
If the circuit breakers are on, switch off
the circuit breakers for at least 5 minutes,
check that the air inlets and outlets are not
blocked, and turn the unit back on.
If after trying these procedures, your
appliance still does not work or if the
problem repeats, call CONVECTAIR or the
nearest CONVECTAIR Service Center.
Ensure that the open window
function is not enabled or that a
window or a door is not open in the
room.
Close the door and / or window, reset the
function by pressing
MANUEL
MANUEL
MANUEL
Auto
twice in a row.
The digital display screen is active,
the heat indicator is off.
Check the temperature setpoint.
Ambient temperature does not require
heat output.
The heater is in Eco mode.
The heater
emits heat
constantly
Check that the temperature setting
has not been changed.
Check that the appliance is not
located near an open door and / or
in a draft.
Set the temperature again.
Close the door or remove the draft.
The device
does not
follow the
program
Check whether the program function
is on
Check the programming
Turn on the program function
Follow program setup instructions.
MANUEL
MANUEL
MANUEL
Auto
Heater requires cleaning. See Maintenance section.
IN ALL OTHER CASES, CONTACT A QUALIFIED PERSON
Troubleshooting