CONTROL SOLUTIONS CS1171, Руководство пользователя

Страница: 38 / 56

CS1171 Hand-Held Programmer User's Manual
Control Solutions LLC Page 38 of 56
Functions Sub-Menu
Parameter Description
Clr flt log Clears all faults from
the controller’s Fault log.
Recall Init Every time the HHP is powered up successfully, it stores the
controller’s current configuration. After changing various
parameters, but before powering down the Hand-Held
Programmer
, this option can restore the controller’s original
configuration of all parameters. If the HHP power is turned off or
lost, memory of the controller’s configuration at the time of the last
power-up is lost as well.
Recall Fact
Restores the factory default configuration of all parameters, if
available (See
Troubleshooting and Diagnostics on page 51 for
details).
Save to Mem1 Stores the current configuration of all parameters to the Hand-Held
Programmer
’s non-volatile memory. Overwrites any configuration
currently stored. Values are not destroyed after recalling from
memory to allow program-cloning of controllers. Values are only
overwritten when
Save to Mem1 is used again.
Recall Mem1 Restores the Hand-Held Programmer's stored configuration of all
parameters from Memory 1.
Save to Mem2 Functions the same as Save to Mem1 but stores to Mem2 .
Recall Mem2 Restores the Hand-Held Programmer's stored configuration of all
parameters from
Mem2 .
Save to Mem3 Functions the same as Save to Mem1 but stores to Mem3 .
Recall Mem3
Restores the Hand-Held Programmer's stored configuration of all
parameters from
Mem3 .
Save to Mem4 Functions the same as Save to Mem1 but stores to Mem4 .
Recall Mem4 Restores the Hand-Held Programmer's stored configuration of all
parameters from
Mem4 .
Save to Mem5 Functions the same as Save to Mem1 but stores to Mem5 .
Use this feature cautiously when program-cloning,
so as not to inadvertently program many
controllers with undesired values.