Description of application and parameters
Application program
43
Number
Name
Object function
Data type
1 | 19 | 37 |
53
Mx: Enable movement
Input
1.001 switch
The detector can be blocked or enabled via the object. Enabling has priority over all other
objects.
Number
Name
Object function
Data type
2
Mx: Switch-off delay
Input
7.005 time (s)
If no movement is detected, the function enters the programmed switch-off and then switches
off. The switch-off delay can be reprogrammed at all times via this object from a different control
element without the aid of ETS. If this value is not to be overwritten during each download, the
parameter "Overwrite setting during download" is to be programmed accordingly.
Number
Name
Object function
Data type
3
Mx: Slave
Input
1.001 switch
This object can be used by a different movement or presence detector to inform the detector
whether it has detected movement or not and thus initiate a "Retrigger" of the detector.
Number
Name
Object function
Data type
4 | 22 | 40 |
56
Mx: Actuator status
Input
1.001 switch
Actuators controlled by the detector can send their status to this input (1 bit). Upon the receipt of
an On/Off telegram on the object the detection of movement is suppressed for the specified
pause time and the switch-off delay is reset.
Number
Name
Object function
Data type
5 | 23 | 41 |
57
Mx: Detection independent of
brightness
Input
1.001 switch
If a 1 is received on this object, the detector switches at every movement independent of
brightness. However, if a 0 is received, the detector switches on only when the brightness drops
below the programmed brightness-value threshold and during movement.
Содержание C4-KNX-BW180 Series
Страница 1: ......
Страница 49: ...Description of application and parameters Application program...
Страница 52: ...Description of application and parameters Application program 200 00556 A 06 26 2018 LW...
Страница 53: ......
