W415-1283 / E / 12.21.16
42
WIRING REQUIREMENTS
It is necessary to hard wire this appliance.
EN
Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired.
This appliance must be electrically connected and grounded in accordance with local codes. In the absence
of local codes, use the current CSA C22.1 Canadian electrical code in Canada or the ANSI/NFPA national
electrical code in the United States.
!
WARNING
DO NOT WIRE 110 VOLTS TO THE VALVE OR WALL SWITCH
This appliance comes equipped with a battery back-up. If this back-up is used, install 4AA batteries (not
supplied) into the holder and connect to the wire harness.
69.7
ACS/IPI
SWITCH
ON / OFF
SWITCH
ORANGE
GREEN
TRANSFORMER
IP
BATTERY
HOUSING
(SUPPLIED IN
MANUAL BAGGIE)
ON / OFF
VALVE
ELECTRONIC
DISCONNECT THESE
CONNECTIONS TO THE
ON/OFF SWITCH AND
CONNECT TO AN
OPTIONAL THERMOSTAT.
A
IPI BOARD
GROUND
EYELET
ND
DC SUPPLY
DFC
GROU
LVE
V
/ CPI
I
O
FF
O
N
Содержание CBHD4N
Страница 22: ...22 W415 1283 E 12 21 16 ound the pipe 21 1B COLLAR VENT PIPE SHIELD...
Страница 23: ......
Страница 66: ......
Страница 67: ...65 W415 1283 E 12 21 16...