Contec VPC-1600, Руководство пользователя, Страница: 56 / 115

4. BIOS setup
VPC-1600 User’s Manual
49
Setting for the power on (AT power operation)
by the AC power-supply turning on
Power Control Configuration
Enable Hibernation
ACPI Sleep State
Power Failure
Wake system with Fixed Time
Wkae up Day of Month
Wake up hour
Wake up minute
Wake up second
Wake on Ring
[Enabled]
[S3 only(Suspend to ...]
[Always off]
[Disabled]
0
0
0
0
[Disabled]
Figure 4.6 Setting for the power on by the AC power-supply turning on
1. Select “Powe Control Configuration” menu from “Configuration” tab.
2. Select “Power Failure” item from “Power Control Configuration” window.
3. Change from “Always off” to “Always on”.
4. After setting the above-mentioned 3, press the <Esc> key and move to “Exit”.
5. Save setup changes with “Save Changes and Reset” and exit.
Factory default setting
This section describes the CMOS Setup Utility’s factory default settings.
By selecting “Load Optimized Defaults” in the Main window of the CMOS Setup Utility, you can
restore our factory settings. For operational instructions, follow the following steps.
1. Select “Load Optimized Defaults” menu from the setup screen.
2. You are prompted to confirm that you are restoring to initial conditions. Press the <Y> and
<Enter> keys.
3. Save setup changes with “Save & Exit Setup” and exit.The following section describes parameters
for the factory default settings of each setting in the CMOS Setup Utility.
Do not change settings other than the CMOS Setup Utility settings specifically described in this
document. The OS may not function normally otherwise.
We assume no responsibility for trouble caused by changing settings other than the CMOS Setup
Utility settings specified.
CAUTION