Contec RP-COM(FIT)H, Руководство пользователя

Страница: 15 / 49

2. Module Nomenclature and Settings
10
RP-COM(FIT)H, RP-COM(FIT)H-AF
MODE Switch
This sets or initializes the operating mode for the RP-COM(FIT)H, RP-COM(FIT)H-AF. The factory
default setting is that the MODE switch setting is used and all switches are set to OFF.
You can use the MODE switch to change the operating mode from the factory default setting to your
desired mode.
For detailed settings, use the utility softwarel.
* Note that it has the meaning only in case of the ID switch value described later being 0 - E.
Table 2.2. MODE Switch
- < Setting the MODE switch before power-on and then turning on the power >
Item Description
Operating mode Set the operating mode
SW1 SW2 Operating mode
OFF OFF Selected in "Through Mode".
OFF ON Selected in "Modem Mode".
ON OFF Selected in "Virtual COM Mode".
ON ON Not used
- < Setting the MODE switch after power-on >
Item Description
Initialization Restore the RP-COM(FIT)H, RP-COM(FIT)H-AF to its factory default
settings.
When SW1 is turned on during normal operation after power-on, the
POWER light and the LED of COM start flashing. Turning the switch OFF
while the LEDs are still blinking (approx. 3 seconds) restores all settings to
their factory default values when the module is next restarted.
* Wait until the POWER and COM LEDs have gone back to their normal
states before rebooting or turning off the power.