Contec LES-RACK, Руководство по эксплуатации и инструкция по установке, Страница: 40 / 54

40
■
General assembly steps
●
Unpacking from the shipping box.
●
Checking the temperature label on the back of the LES-RACK device, whether the
limit temperature has not been exceeded during transport.
●
Fastening guide rails in the cabinet in a horizontal position and securing them properly
with screws.
●
Inserting the LES-RACK device into the pre-prepared guide rails. Securing the device
with 4 screws.
●
Connecting the LES-RACK device to the network with a power cable.
●
Connecting the temperature sensor to the RJ11 port and software activation using the
web interface.
●
According to the requirements of connecting external security peripherals (manual
release button, external sounder LED Beacon , ...) and their Software activation using
the web interface.
●
Activate the back up battery with a thin pin by pressing the microswitch (small hole
next to the network connection)
●
Check placement location and its cleanliness.
Use Checklist .
○
Signaling
Local signaling is provided by multi-colored LEDs placed on the front panel of the device
underneath of labels that describe a respective device function or system status. The
individual states are described in table no. 5.
The meaning on abbreviations in the „colour“ column is the following:
R - red
G - green
Y - yellow
B - blue
O - orange
R/G - alternating red and green
Y/R - alternating yellow and red
The meaning on abbreviations in the „state“ column is the following:
- - - - Off
S50% - Dimmed
S - Continuous Glowing
B - Blinking