2. Setup
16
DIO-1616L-PE, DI-32L-PE, DO-32L-PE
Step 2 Setting the Hardware
This section describes how to set the board and plug it on your PC.
The board has some switches to be preset.
Check the on-board switches before plugging the board into an extension slot.
The board can be set up even with the factory defaults untouched. You can change board settings later.
Parts of the Board and Factory Defaults
Figure 2.1. shows the names of major parts on the board.
Note that the switch setting shown below is the factory default.
SW1
BOARD ID
SW1
BOARD ID
(SW1)
01
2
3
4
5
6 7
9A
B
C
D
E
F
8
DIO/DI/DO-xxL-PE
- Interface connector
(CN1)
- Board ID setting switch
Figure 2.1. Component Locations
Содержание DI-32L-PE
Страница 7: ...vi DIO 1616L PE DI 32L PE DO 32L PE...
Страница 41: ...2 Setup 34 DIO 1616L PE DI 32L PE DO 32L PE...
Страница 51: ...3 External Connection 44 DIO 1616L PE DI 32L PE DO 32L PE...
