—
How To Use Collection Data
—
M2M Gateway PLC Communication Settings
—
85
—
1.
Data Transfer Function (Original function)
settingss explained here.
The settings of the "PLC Data Transfer Service" and the "Data Transfer with CONPROSYS VTC" are
described to send PLC information.
-Data transfer with HTTP/HTTPS
Earlier, this function is stated as the original of Contec, however, it is a file transfer via HTTP that is
used in general.
This is used when sending data to such as IoT Cloud service "CONPROSYS CDS2" provided by the
CONTEC.
The procedure of the data reception can be viewed in the "Data collection software" (the sample
program for checking the reception procedure) on the CONTEC website and it is widely available.
Data collection software
https://www.contec.com/products-services/daq-control/iiot-conprosys/software/
Data Transfer URL
First, setting URL for sending data is explained before describing the data transfer setting.
This URL setting is commonly used for “PLC Data Transfer Service", "Data Transfer with CONPROSYS
VTC”, and "Data Transfer Service".
-Setting the URL
From Setting menu, go to the "Data Transfer", and set details of the "Data Transfer URL".
*Regarding the Data Transfer URL, refer to the instructions in the " CONPROSYS CDS2 contract "
or the "Data collection software".
*"Cycle (min)", "Cloud Key", and "CDS2 Format (Enable/Disable)" are usable when data transfer
is selecting the "Data Transfer Service" only.
*When the "CDS2 Format (Enable/Disable)" is disabled, the data are sent in CDS format (the old
service).
*Enabling the "Auto Backup" starts up the function to copy-backup the data into SD card.