Contec CNT-3208M-PE, Руководство пользователя, Страница: 21 / 81

2. Setup
14
CNT-3208M-PE
Setting the Board ID
If you install two or more boards on one personal computer, assign a different ID value to each of the
boards to distinguish them.
The board IDs can be set from 0 to Fh to identify up to sixteen boards.
If only one board is used, the original factory setting (Board ID = 0) should be used.
Setting Procedure
To set the board ID, use the rotary switch on the board. Turn the SW1 knob to set the board ID as shown
below.
Figure 2.2. Board ID Settings (SW1)
Setting the Logic of External Control Signals
This product has one pin for external control output signals per channel.
Positive or negative logic can be selected for the output signals for each channel. Select either logic
depending on the specifications of the external device to be connected.
Setting Procedure
To set the logic for output signals, use the on-board DIP switch (SW2). See Figure 2.3 below to set the
SW2.
Bit Channel Negative logic Positive logic
1 ch0 ON OFF
2 ch1 ON OFF
3 ch2 ON OFF
4 ch3 ON OFF
5 ch4 ON OFF
6 ch5 ON OFF
7 ch6 ON OFF
8 ch7 ON OFF
Figure 2.3. Board ID Settings (SW2)
BOARD ID
SW1
01
23
45
67 9ABC
D
EF
8
Factory setting:
(Board ID = 0)
Factory setting: All ON
SW2
ON
1 2 3 4 5 6 7 8