Contec AO-1608L-LPE, Руководство пользователя

Страница: 28 / 77

2. Setup
AO-1616L-LPE, AO-1608L-LPE
21
Step 5 Checking Operations with the Diagnosis
Program
Use the diagnosis program to check that the board and driver software work normally, thereby you can
confirm that they have been set up correctly.
What is the Diagnosis Program?
The diagnosis program diagnoses the states of the board and driver software.
It can also be used as a simple checker when an external device is actually connected.
Using the “Diagnosis Report” feature reports the driver settings, the presence or absence of the board,
I/O status, and interrupt status.
Check Method
To check the analog output data, connect to an external signal source.
The figure below shows an example of checking by connecting to an external signal.
The analog output example illustrated below is an example of using analog output channel 0.
Use the diagnosis program to perform an operation check.
Connection diagram
< Analog Output >
Figure 2.4. Connection diagram
e.g.Tester
Analog Ground
(CN1)24pin
CH0
(CN1)25pin
Interface connector