CONSTRUCTA CH230252, Инструкция по эксплуатации

Страница: 54 / 60

54
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
When removing the inner panels, pay attention to the order in
which the panels are removed. In order to reassemble the
panels in the correct sequence, follow the number which
appears on each panel.
Removal
1.
Detach the oven door and lay on a cloth with the handle
facing down.
2.
Unscrew the cover at the top of the oven door. To do this,
undo the left and right screws (fig. A).
3.
Lift the top panel up and out (fig. B).
4.
Unscrew the retaining clips on the right and left and remove
them (fig. C). Remove the middle panel.
5.
Pull the lower panel diagonally upwards and out.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left on both panels.
1.
Insert the lower panel diagonally towards the back (fig. A).
2.
Insert the centre panel (fig. B).
3.
Stick the retaining clips onto the right and left-hand side of
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. C).
4.
Insert the uppermost panel diagonally towards the back. The
smooth surface must face outwards.
5.
Put the cover back in place and screw it on.
6.
Attach the oven door.
Do not use the oven again until the panels have been
correctly fitted.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
ã=
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.
Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.
Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.
Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.
Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.
Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.
Insert the hook-in rack at the front as far as it will go and push
downwards (figure D).
% $
&
% $
&
$ %
D D
& '