Manual Electrophoresis Power Supply, rev. 32/2018
5
Detection
Choose
DETECTION
to alter the actions when a low current or a power failure is detected.
Low Current
When a very low current is detected as soon as the Voltage limit has been reached, the power will shut down
the procedure. An
will be given.
When in
SETUP
, follow these steps to select
LOW CURRENT
and press
✓
:
Decide whether or not the output Voltage should shut down at a too low output current and
press
✓
.
Power fail
When the detection of a power failure is enabled, the power supply will continue to proceed the procedure if
the timer was still running at the moment that the power failure occurred. After powering it again, the power
supply will automatically proceed with the experiment for the remaining time.
When in
SETUP
, follow these steps to select
POWER FAIL
and press
✓
.
Decide whether or not the instrument should proceed with the experiment for the remaining time
after a power failure and press
✓
.
Data
Starting from version 1.5 is this
DATA
menu available. Check our support website (
) for
firmware updates of the instrument.
The instrument logs all experiments into its internal memory and will hold the last 250 experiments or less if
the memory size would be exceeded. Older data will be lost. The available data can be read using the DIS3
(USB-version) software which is freely distributed on our website.
Info
The menu in the instrument allows to show information about the memory status of the logged data.
When in
SETUP
, follow these steps to see the status of the data log memory:
When the info appears, press
✓
to return.
SYSTEM
DETECTION
DATA
INFO
DETECTION
LOW CURRENT
POWER FAIL
SYSTEM
DETECTION
DATA
INFO
DETECTION
LOW CURRENT
POWER FAIL
SYSTEM
DETECTION
DATA
INFO
DATA
INFO
ERASE
