Consilium Salwico CS4000, Руководство по установке

Страница: 84 / 277

User Guide Chapter 3: Installation
32
Salwico CS4000
Testing
After installation of the fire alarm system the different parts of the
system shall be tested to assure correct function. The CS4000 has a
special test mode, which makes the testing easier. When a zone is in
test mode it will not activate any external alarm devices or controls in
case of a fire. Each tested detector and manual call point will indicate
activation with a red LED. The units in alarm will also be
automatically reset when the heat or smoke concentration is under the
alarm level or if the manual call point is reset. Fire alarms from zones
not in test mode will not be inhibited. Detectors and manual call points
in the zone will blink during test mode. The tested zone will
automatically return to normal operation after two hours.
Test a fire-detecting zone
Put the zone into test mode under: Menu/3 Disconnections/1 New
disconn./ 5 Test Mode
Enter the zone number and confirm with
OK
button
The indications DISC., Test and Zone/Unit will be lit to confirm the
test mode.
It is now safe to test each detector, manual call point etc in this fire
zone during two hours. Use suitable testing equipment.
All alarms will be listed under: Menu/7 History/1 Fire History List
Reset test mode
After testing it is important to return the tested zone into normal
condition again. Make sure that there is no detectors or manual call
points still in alarm before leaving test mode.
The zones in test mode are listed in the disconnection list, found under:
Menu/3 Disconnections /2 Disconnection list.
Choose the zone in the disconnection list and then press
RESET
.
Test the control unit display
It is possible to test the alphanumerical display, all indications on the
control panel and the local buzzer with the function Test display,
found under: Menu/5 Settings/4 Test display.