Conrad W-210, Руководство по эксплуатации

Страница: 67 / 156

67
• To set the hours, push the button (C) “ST/STP” or (D) “RESET” repeatedly until the desired
hours are shown.
• Push the button (B) “MODE” to switch to setting minutes. The top of the display shows “MIN”.
• To set the minutes, push the button (C) “ST/STP” or (D) “RESET” repeatedly until the desired
minutes are shown.
• To return to the hours, push the button (B) “MODE” again.
To leave the setting menu and to save the values, push the button (A) “ADJ/EL”.
• After leaving the setting menu, the alarm is switched on auto-
maically.
You can tell this if “ON” and the alarm symbol are shown at the
bottom of the display.
The alarm symbol is always displayed while the alarm is active. It
doesn’t matter in which mode the pulse watch currently is.
c) Switch alarm/wake-up time on/off
To switch the alarm/wake-up function on or off, briefly push the button (C) “ST/STP” while the
alarm time flashes on the display.
The left figure shows when the alarm is off, the right one when the alarm is on.
d) End alarm-/wake-up signal
If the alarm/wake-up signal is output at the set time, it can be terminated by pushing one of
the 4 buttons. While the alarm/wake-up signal is active, all other functions of the 4 buttons are
deactivated until you switch it off!